Automotive Manual PDF

This system is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
• This product must be installed by qualified personnel according to these instructions and and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area. Do not use in a closed garage or indoors
(more…)

[Read more →]

This remote start product is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
DO NOT INSTALL THIS UNIT INTO A MANUAL TRANSMISSION VEHICLE AS IT COULD RESULT IN SERIOUS INJURY OR DEATH.
• This product must be installed by qualified personnel according to these instructions and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area.
Do not use in a closed garage or indoors.
(more…)

[Read more →]

This system is intended for installation on vehicles equipped with automatic transmissions and electronic fuel injection only!
DO NOT INSTALL THIS SYSTEM INTO A MANUAL TRANSMISSION VEHICLE AS IT COULD RESULT IN SERIOUS INJURY OR DEATH.
• This product must be installed by qualified personnel according to these instructions and and observing all safety features.
• The system should be placed into the valet mode when parked inside a garage or being left for service.
• Always notify service personnel that the vehicle is equipped with a Remote Starter.
• Only start the vehicle in a well ventilated area. Do not use in a closed garage or indoors.
(more…)

[Read more →]

The Suzuki CAT1 consists of the following main components;
• Installed CAT1 main unit
• 2 x remote transmitters
• Installed protecting switch
• Installed system fuse and spare fuse
• LED system indicator
(more…)

[Read more →]

Mounting the Vacuum Reservoir (10067563)
1. Take out the windshield washer fluid bottle from passenger side by removing the two 10-mm nuts holding it in place.
2. Remove the clutch master cylinder reservoir by popping out the two push clips that attach it to the bracket.
3. The vacuum reservoir is going to be mounted upside-down on the cowl wall with the Amp opening on the top and the Main opening on the bottom.
4. Mount the reservoir using a rivet gun and two 3/16-in rivets, making sure it is not in contact with the hood release or clutch master cylinder reservoir bracket.
5. Replace the clutch master cylinder reservoir by snapping the two push clips back into place.
(more…)

[Read more →]