Removing stock carburetor and cables
1. Remove seat and gas tank. Make sure fuel petcock is in “off” position.
2. Remove throttle cables and throttle housing.
3. Remove voltage regulator from left side of frame to allow carb to come out.
4. Remove stock carburetor.
5. Unplug TPS (throttle position sensor) and tape end off coming from bike.
6. Stuff a dry, clean rag into the intake manifold to keep debris from entering engine.
7. Remove engine breather lines along with plastic canister on right side of bike.
(more…)
2000-LATER Suzuki DRZ400/400S INSTRUCTION SUPPLEMENT
October 11th, 2008 · No Comments
Toyota Camry Charging System pdf
June 10th, 2008 · No Comments
The generator is a small, high speed, high performance type with an voltage regulator incorporat– ed. The voltage regulator uses integrated circuits and controls the voltage produced by the generator.
PRECAUTION
1. Check that the battery cables are connected to the correct terminals.
2. Disconnect the battery cables when the battery is given a quick charge.
3. Do not perform tests with a high voltage insulation resistance tester.
4. Never disconnect the battery while the engine is running.
(more…)
