Automotive Manual PDF

RSS Feed

The Resources for Automotive

03-05 Hummer H2 P/N 200-183 Installation Instructions

February 15th, 2010 · No Comments

Installation Instructions. Read Me!
I) DISCONNECT NEGATIVE (-) BATTERY CABLE.
II) Remove the Factory Air Box
a) Loosen Mass Air Meter hose clamps and set meter aside.
b) Unbolt the three air box hold down fasteners and save the bolts. See Fig#1
c) Lift out & remove the factory air box assembly from vehicle.
d) Remove and save the three rubber grommets, inserts and bolts. See Fig#2
(more…)

[Read more →]

03-04 Chevy Duramax / 01-04 GMC Duramax 6.6L Installation Instructions

August 29th, 2009 · No Comments

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
(more…)

[Read more →]

Ford Focus Installation Instructions pdf

March 27th, 2008 · No Comments

Tools & Materials Needed: 1. Utility Knife 2. Wire Crimper 3. Torx™ Wrenches 4. Hex Nut Drivers 5. Drill and Bits 6. Phillips Head Screw Driver 7. Crank Spring Removal Tool (Special Tool, available at most Auto Parts Stores) – or – 8. Flat Screw Drivers (2) 9. Add-A-Circuit™ fuse adapter 10. Silicon Sealant (Clear or Black) Procedure: (Approximate time to complete installation: 3 – 4 hours) A. Removing the Door Panel Coverings 1. For ease of installation, do both sides at the same time. 2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down Position. With either the Crank Spring Removal Tool, or a flat Screwdriver, remove the spring, located in a slot on the back of the crank.
(more…)

[Read more →]