Automotive Manual PDF

A) To remove left handlebar:
1. Remove bar end weights.
2. Cut two small cable ties holding wire loom from left control housing (PHOTO 1)­ one under the handlebar anti­ rotation bracket and the other attaching the wire loom to the underside of the top triple clamp. Do the same on the right side.
3. Remove the clutch master cylinder from the left bar.
4. Remove the forward plastic control housing cover (2 screws) Loosen the two screws that sandwich the bar between the forward plate and the rear half of the left control housing(PHOTO 2).
5. Remove the two screws attaching the left handgrip sleeve to the left bar tube­1 on top and 1 on the bottom (PHOTO 3).
6. Remove the anti rotation bracket holding screw located under the top triple clamp (PHOTO 4).
7. Loosen the two screws clamping the left bar to the triple clamp. Only the inner most crew needs to be removed to withdraw the stock bar.
(more…)

[Read more →]

Heli Bars are designed to safely increase your riding comfort, however it is imperative that these instructions be followed to ensure correct installation. Failure to follow these instructions could result in improper installation and create a dangerous control situation.
(more…)

[Read more →]

This advance edition of the 2008 Ford RV & Trailer Towing Guide provides trailer towing weights for the listed early-introduction 2008 models. It is available only online for the benefit of customers ordering any of these models prior to the September printing of the complete Guide, which will include more detailed RV and towing information. Until then, this expanded information may be accessed through the 2007 RV & Trailer Towing Guide available online or in printed form (see your Ford Dealer).
(more…)

[Read more →]

Presuming you are familiar with the principles of a modern EFI engine, (if not please review the Introduction, in the Scan Tool manual called “Fundamentals of OBD II EFI Engines”:) it may be surprising to learn that it is possible that these engines can be electronically “tuned.” Just as in the “good old days” when (for example) adding a modified camshaft required new jets for the carburettor, and changing the springs and weights on the distributor advance, this ability still exists, and is necessary, when making changes to an EFI engine.
(more…)

[Read more →]

Heli Bars are designed to safely increase your riding comfort, however it is imperative that these instructions be followed to ensure correct installation. Failure to follow these instructions could result in improper installation and create a dangerous control situation. If you have any questions about installation call Heli Modified, Inc. at 1­800­859­4642. 1. Remove the damper weights from the ends of the bars. 2. On the right bar, loosen the throttle housing screws enough to spread the housing and disengage the locating pin. It is not necessary to take the throttle housing apart. 3. Remove the front brake master cylinder from the stock bar.
(more…)

[Read more →]