Automotive Manual PDF

Tools Recommended: metric deep socket set, metric & American open end wrench set, 9/64th Allen wrench, Teflon tape, wire cutters, terminal crimpers.
Follow the included diagram exactly. This product uses two different but visually similar threads. 1/8” NPT and 1/8” BSPT may appear to be the same thread, but they are not. Do not assemble any portion of this kit in any way other than described. Doing so will result in stripped threads and oil leaks.
(more…)

[Read more →]

Time and Ease: Medium difficulty ­ 1­2 hours Tools/Supplies: Wire cutters/strippers, small rotary tool (Dremel), screwdriver, 10 or 15 amp inline fuse, 12v marine outlet with extra wire (Walmart), end connectors that will fit around your battery terminals
Step 1 ­ Open your glove box and locate the dimple or hole in the middle, where the outlet is already on the Forza version. (see photo section) Step 2 ­ If there is a hole already, try fitting the outlet in it. Doesn’t fit or no hole? Try grinding out some of the plastic with a Dremel or rotary tool. BE CAREFUL! You don’t want to grind out too much.
(more…)

[Read more →]

The following are some general guidelines that will simplify the installation process and make owning your GrilleGuy grille an enjoyable experience.
• Always place the head of the zip ties behind the grille for a cleaner more custom look. A galvanized /stainless picture hanging wire (not included) can be substituted for the cable ties.
• Occasional use of an aluminum polish will give your raw grille a brilliant shine
Hardware list:
2 perforated aluminum grille inserts
10 weather resistant nylon cable ties
(more…)

[Read more →]

Please review complete instructions prior to installing.
Step#
1 Verify you have all of the following parts included in the kit:
(1) JLT painted pipe with IAT and PCV fittings, (1) Rubber Reducer w/ clamps, (1) Rubber coupler w/clamps,
(1) S&B 4×12” Oval Air Filter, (1) MAF Adaptor with bolts, (1) Wire Harness Extension Kit,
(1) Wire Harness Extension Cover, (1) section of 3/4” hose, and (1) section of 5/8” hose
(more…)

[Read more →]

If you have a high mileage vehicle, we recommend changing the fuel filters inside the module. The primary fuel filter and the inlet filter sock are not currently available as service parts from GM so changing these filters requires purchasing an all new fuel pump module. Complete fuel pump modules are available from LPE (see part number listed above).

Installation Instructions:
1) Follow the GM service instructions for removing the fuel pump module from your vehicle. Service manuals are available from Helm Inc. ( http://www.helminc.com ).
2) Unplug all the wires from the bulkhead connector at the top of the module.
3) Carefully remove the outer “bucket” from the fuel pump module assembly.
4) Using a small pocket screwdriver, carefully pry the fuel sock (fuel pump inlet filter) from the center pin on the bottom of the fuel pump. Save the fuel sock. You will be reusing the fuel sock when you reassemble the module.
5) Using wire cutters, clip the small ground wire as close to the fuel pump terminal as possible.

Get pdf LS2 equipped SSR & Trailblazer SS High Fuel Pump Upgrade Kit Installation Instructions

[Read more →]