Automotive Manual PDF

There have been some changes to time allowances for engine and suspension assemblies on recently scheduled vehicles. Previous schedules have shown separate remove and replace allowances for engines and suspension assemblies of approximately 8.00 to 9.50 hours depending on make and model. When formulated, these allowances reflected a component assembly of the motor, suspension and engine compartment hardware.
(more…)

[Read more →]

The wire colors on my vehicle do not match the colors in your diagram. What do I do?
Unfortunately vehicle manufactures frequently change the color of the wires in their wiring harnesses. The wire that we need locate is the factory door-ajar signal located inside each door. You can find this circuit by removing the door panel and physically tracing the wires leading to the door latch / switch. Once you have located the bundle of wires that go to the switch you will need to isolate the door-ajar circuit. This circuit will be a “negative switching” circuit. Negative switching indicates that the circuit will be in a “ ground “ state where the circuit is connected to the minus or negative side of the battery with the door open (Except 02 – 03 Ford Super Duty and 08 Ford Super Duty where the circuit is closed to ground with the door shut). With the door closed the circuit will sometimes show a very small amount of current or nothing at all.
(more…)

[Read more →]

These installation instructions are only for use within the BMW dealer organisation. The installation time is approx. 5.5 hours but may vary depending on the condition of the car and the equipment in it. Specialist knowledge of BMW cars is required for the installation work. All work is to be completed using the latest BMW
– Repair instructions,
– Circuit diagrams,
– Service manuals,
– Work instructions,
– Diagnostics manuals
(more…)

[Read more →]