Automotive Manual PDF

1. Assemble your motor/bracket assembly. Your actuators came with two Phillips head screws. Use these to secure your the actuator to the bracket.
2. Remove the door panel and 3 torque screws that hold the latch. For most GM vehicles, screw size is T30.
3.Using a pick or similar tool, un-snap the plastic retaining clip that holds the rod to the back of the inside handle. Be careful not to damage the rod; you will reuse it.
4. Remove the clip that holds the wiring to the door and push it through. This step is not required if your vehicle doesn’t have power door locks.
(more…)

[Read more →]

Thank you for purchasing Granatelli Signature Series cold air induction system. Like all Granatelli Motor Sports products, great pride and precision craftsmanship went into making these parts.
1. Disconnect your negative battery cable
2. Sliding the red safety tab backward, unplug your factory mass airflow sensor. Depress the black and slide the connector from the sensor itself.
3. Remove the breather tube from both the stock air intake and the valve cover; you will no longer be using this piece.
4. Remove the 10mm bolt holding the stock air box to the inner fender. Be sure to keep track of this bolt, you will be reusing it later (step 7).
(more…)

[Read more →]

INSTALLING THE RADIO GEAR
Skip if already assembled in RTR version
a. Install the receiver switch onto the servo mount beside the steering servo with 2 tap screws.
b. Install the steering servo onto the servo mount with four tap screws. (Note the output shaft should be centered between the chassis frames.)
c. Install the throttle servo onto the servo mount with 4 tap screws. The mounting position is shown in this manual.
(more…)

[Read more →]

1. Locate the oil filter flange on your motor and find the stock oil pressure sender. To access this location fully, certain emissions devices or the intake manifold may need to be removed. Remove the wiring harness from the stock oil pressure sender and move aside. Using a 24mm deep socket, unscrew the sender.
2. Install the included M10×1 adaptor in the stock oil pressure sender port. Start threads by hand and tighten snug using an open end wrench. Do not over tighten this adaptor! Install one end of the 12” extension hose and use an open end wrench to tighten.
(more…)

[Read more →]

PREPARATION FOR INSTALLATION
1. Be sure that the vehicle is parked on level concrete and the parking brake is on.
2. Place stops in front of and behind rear tires.
3. Consult owner’s manual for proper lifting and wheel removal procedures before lifting front of vehicle.
4. Place jack stands under vehicle for added stability.
5. Remove wheel.
(more…)

[Read more →]

Gather required tools. Please gather the following tools before you begin the installation: * Power Drill * Utility Knife. * 3/16 drill bit. * Duct Tape * 9mm or 11/32 open ended wrench. * Pliers. * 9/64″ Hex Key or Allen Head wrench * Small piece of cloth. * Flat file for filing metal. * Zip tie - medium size. * Rasp file or round file. * Body color touch up paint. * Fine permanent marker. * Phillips screw driver. Step 2 - Unpack fuel door kit and verify contents. Check items you removed from the box. You should Copyright © 2003 Redline Tuning LLC. All Rights Reserved.
(more…)

[Read more →]